Standard Active Last Updated: May 08, 2020 Track Document
ASTM D6768/D6768M-20

Standard Test Method for Tensile Strength of Geosynthetic Clay Liners

Standard Test Method for Tensile Strength of Geosynthetic Clay Liners D6768_D6768M-20 ASTM|D6768_D6768M-20|en-US Standard Test Method for Tensile Strength of Geosynthetic Clay Liners Standard new BOS Vol. 04.13 Committee D35
$ 55.00 In stock

Significance and Use

5.1 This test method may be used for the acceptance testing of commercial shipments of GCLs, but caution is advised since information about between-laboratory precision is incomplete. Comparative tests as directed in 5.1.1 may be advisable.

5.1.1 In cases of a dispute arising from differences in reported test results when using this test method for acceptance of shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias. The two parties should take a group of test samples that are as homogeneous as possible and which are from the lot of material in question.

5.2 Some modification of clamping techniques may be necessary for a given GCL, depending upon its structure. Specimen clamping may be modified as required at the discretion of the individual laboratory, provided a representative tensile strength is obtained. In any event, the procedure described in Section 10 of this test method for obtaining tensile strength must be maintained.

5.3 This test method is applicable for testing GCLs as received. It is used with a constant rate of extension type tension apparatus.

Scope

1.1 This test method establishes the procedures for the measurement of tensile strength of a geosynthetic clay liner (GCL). This test method is strictly an index test method to be used to verify the tensile strength of GCLs. Results from this test method should not be considered as an indication of actual or long-term performance of the geosynthetic(s) in field applications.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.13
Developed by Subcommittee: D35.04
Pages: 3
DOI: 10.1520/D6768_D6768M-20
ICS Code: 59.080.70