| ||Format||Pages||Price|| |
|4||$46.00||  ADD TO CART|
|Hardcopy (shipping and handling)||4||$46.00||  ADD TO CART|
Significance and Use
3.1 The sulfur content can be used to characterize a silane or an admixture of silane and carbon black. It depends mainly on the average length of the sulfur chain.
1.1 These test methods cover the determination of the sulfur content of silanes, or of admixtures of silane and carbon black, of the type bis-(triethoxysilylpropyl)sulfane. The following test methods are included:
Test Method A: Combustion in an Oxygen Flask and Subsequent
Test Method B: High-Temperature Combustion with Infrared
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1193 Specification for Reagent Water
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ICS Number Code 83.060 (Rubber)
UNSPSC Code 13101607(Rubber compound)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D6741-10(2019), Standard Test Methods for Silanes Used in Rubber Formulations