| ||Format||Pages||Price|| |
|2||$48.00||  ADD TO CART|
|Hardcopy (shipping and handling)||2||$48.00||  ADD TO CART|
This practice establishes the standard procedures for evaluating the resistance of pre-stressed prepainted metal panels to cracking and loss of adhesion, or both, after accelerated aging by boiling water. This method shall require the use of boiling water bath, 10x magnifier, Scotch #610 adhesive tape or its equivalent, and deionized or other water as reagent.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This practice can be used to evaluate the resistance of a pre-stressed prepainted metal panel to cracking and loss of adhesion, or both, after accelerated aging by boiling water. Most coil coated products are formed and bent into specific shapes to produce a final product. These operations introduce stresses, which may be relieved by cracking of the coating after aging.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)
D4145 Test Method for Coating Flexibility of Prepainted Sheet
E643 Test Method for Ball Punch Deformation of Metallic Sheet Material
ICS Number Code 19.040 (Environmental testing); 91.140.65 (Water heating equipment)
UNSPSC Code 40101826(Commercial water heaters)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D6665-09(2019), Standard Practice for Evaluation of Aging Resistance of Pre-stressed Prepainted Metal in a Boiling Water Test, ASTM International, West Conshohocken, PA, 2019, www.astm.orgBack to Top