| ||Format||Pages||Price|| |
|8||$52.00||  ADD TO CART|
|Hardcopy (shipping and handling)||8||$52.00||  ADD TO CART|
Significance and Use
4.1 The use of the body measurement information in will assist manufacturers in developing patterns and garments that are consistent with the current anthropometric characteristics of the population of interest. This practice should in turn reduce or minimize consumer confusion and dissatisfaction related to apparel sizing. (Also refer to ISO 3635 Size Designation Procedures.)
4.2 Three-dimensional avatars depicting each of the mature mens sizes in short, regular and tall, were created by Alvanon, Inc. and included in this standard to assist manufacturers in visualizing the posture, shape, and proportions generated by the measurements charts in the accompanying Tables. (Avatar 1-6) See .
FIG. 1 Mature Men - Short
FIG. 2 Mature Men - Regular
FIG. 3 Mature Men - Tall
1.1 These tables list body measurements of mature male figure type, age 35 and older, sizes 34 through 52 in Short, Regular, and Tall. Although these are body measurements, they can be used as a baseline in designing apparel for Mature Men in this size range when considering such factors as fabric type, ease for body movement, styling, and fit.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ISO StandardISO 3635 Size Designation of Clothes, Definitions, and Body Measurement Procedures
D123 Terminology Relating to Textiles
D5219 Terminology Relating to Body Dimensions for Apparel Sizing
ICS Number Code 17.040.99 (Other standards relating to linear and angular measurements); 61.020 (Clothes)
UNSPSC Code 53100000(Clothing)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D6240 / D6240M-12(2021)e1, Standard Tables of Body Measurements for Mature Men, ages 35 and older, Sizes Thirty-Four to Fifty-Two (34 to 52) Short, Regular, and Tall, ASTM International, West Conshohocken, PA, 2021, www.astm.orgBack to Top