ASTM D5869 / D5869M - 07A(2018)e1

    Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials

    Active Standard ASTM D5869 / D5869M | Developed by Subcommittee: D08.02

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF 2 $41.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $41.00   ADD TO CART


    Significance and Use

    5.1 Roofing and waterproofing materials and systems undergo changes in physical properties as a result of being subjected to heat. They also undergo changes in physical properties as they age in service. Since service conditions vary widely, any relationship between changes observed in this practice and changes in service must be established by the user of this practice.

    1. Scope

    1.1 This practice establishes a procedure and conditions of temperature and time for heat exposure of roofing and waterproofing materials and systems in the presence of air.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D883 Terminology Relating to Plastics

    D1079 Terminology Relating to Roofing and Waterproofing

    D1566 Terminology Relating to Rubber

    E145 Specification for Gravity-Convection and Forced-Ventilation Ovens

    E230/E230M Specification for Temperature-Electromotive Force (emf) Tables for Standardized Thermocouples

    E1137/E1137M Specification for Industrial Platinum Resistance Thermometers

    E2251 Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids


    ICS Code

    ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products); 91.100.50 (Binders. Sealing materials)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D5869_D5869M-07AR18E01

    Citation Format

    ASTM D5869 / D5869M-07A(2018)e1, Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top