| ||Format||Pages||Price|| |
|2||$44.00||  ADD TO CART|
|Hardcopy (shipping and handling)||2||$44.00||  ADD TO CART|
Significance and Use
4.1 These tests are mainly intended for referee purposes but can also be used for quality control of rubber production.
4.2 The total and water soluble ash content of a rubber can affect the properties of compounded, vulcanized rubber such as water absorption, swell, electrical properties, etc.
1.1 This test method covers a test method for the determination of ash content in synthetic rubber.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D5668 Test Methods for Rubber From Synthetic SourcesVolatile Matter
ICS Number Code 83.060 (Rubber)
UNSPSC Code 13100000(Rubber and elastomers)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D5667-95(2019), Standard Test Method for Rubber From Synthetic Sources—Total and Water Soluble Ash, ASTM International, West Conshohocken, PA, 2019, www.astm.orgBack to Top