ASTM D5657 - 07(2014)
Standard Test Method for Fluid Tightness Ability of Adhesives Used on Threaded Fasteners
| Format | Pages | Price | ||
 |
2 | $40.00 |  ADD TO CART |
|
 |
Hardcopy (shipping and handling) | 2 | $40.00 | ADD TO CART |
Historical Version(s) - view previous versions of standard
Significance and Use
5.1 Thread-locking adhesives are often used on threaded fasteners in sealing applications. This test method is used to determine an adhesive's ability to provide sealing capabilities under specified conditions.
1. Scope
1.1 This test method covers the determination of the ability of adhesives used for locking and sealing threaded fasteners, to make leak-tight assemblies.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D907 Terminology of Adhesives
SAE Standard
SAE J429 Mechanical and Material Requirements for Externally Threaded Fasteners Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.ICS Code
ICS Number Code 83.180 (Adhesives)
UNSPSC Code
UNSPSC Code 44122119(Self adhesive fasteners)
Referencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D5657
Citation Format
ASTM D5657-07(2014), Standard Test Method for Fluid Tightness Ability of Adhesives Used on Threaded Fasteners, ASTM International, West Conshohocken, PA, 2014, www.astm.org
Back to Top