| ||Format||Pages||Price|| |
|7||$48.00||  ADD TO CART|
|Hardcopy (shipping and handling)||7||$48.00||  ADD TO CART|
Significance and Use
The use of the body measurement information in Table 1 and Table 2 will assist manufacturers in developing patterns and garments that are consistent with the current anthropometric characteristics of the population of interest. This practice should in turn reduce or minimize consumer confusion and dissatisfaction related to apparel sizing. (Also refer to ISO 3635.)
Three-dimensional avatars depicting each of the missy sizes and sub category curvy and straight on certain measures, were created by Alvanon, Inc. and included in this standard to assist manufacturers in visualizing the posture, shape, and proportions generated by the measurements charts in the accompanying tables. (Avatar 1-6) See Fig. 1 and Fig. 2.
1.1 These tables list body measurements of adult female misses figure Type sizes 00 through 20. Although these are body measurements, they can be used as a baseline in designing apparel for Missy in this size range when considering such factors as fabric type, ease for body movement, styling, and fit.
1.2 These tables list body measurements for the complete range of Missy sizing.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ISO StandardsISO 3635 Size Designation of Clothes, Definitions, and Body Measurement Procedures
ICS Number Code 61.020 (Clothes)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D5585-11e1, Standard Tables of Body Measurements for Adult Female Misses Figure Type, Size Range 00–20 , ASTM International, West Conshohocken, PA, 2011, www.astm.orgBack to Top