ASTM D5469 / D5469M - 12 Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems (Withdrawn 2021)

You are being redirected because this document is part of your ASTM Compass® subscription.

This document is part of your ASTM Compass® subscription.

ASTM D5469/D5469M-12

Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems (Withdrawn 2021)

Withdrawn Standard: ASTM D5469/D5469M-12 | Developed by Subcommittee: D08.06

	Format	Pages	Price
	PDF	7	$62.00	ADD TO CART

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center Visit Copyright Clearance Center

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center

Visit Copyright Clearance Center

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center

Visit Copyright Clearance Center

ASTM License Agreement

Withdrawn Rationale:

This guide covered the application of new roofing systems consisting of spray applied polyurethane foam insulation, elastomeric protective coatings, and optional mineral granules.

Formerly under the jurisdiction of Committee D08 on Roofing and Waterproofing, this guide was withdrawn in March 2021 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

1. Scope

1.1 This guide covers the application of new roofing systems consisting of spray applied polyurethane foam insulation, elastomeric protective coatings, and optional mineral granules. This guide does not apply to retrofit or remedial applications.

1.2 Design criteria associated with the installation of spray in place polyurethane foam are beyond the scope of this specification.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C1029 Specification for Spray-Applied Rigid Cellular Polyurethane Thermal Insulation

D451 Test Method for Sieve Analysis of Granular Mineral Surfacing For Asphalt Roofing Products

D1079 Terminology Relating to Roofing and Waterproofing

D4442 Test Methods for Direct Moisture Content Measurement of Wood and Wood-Base Materials

D7119 Guide for Sampling Spray Polyurethane Foam and Coating in Roofing

Other Standard

SSPC SP-6 Steel Structures Painting Council Available from Society for Protective Coatings (SSPC), 40 24th St., 6th Floor, Pittsburgh, PA 15222-4656.

Spray Polyurethane Foam Alliance Documents

NRCA/SPFA Manual for Inspection and Maintenance of A Guide for Building Owners

Referencing This Standard

Link Here

Link to Active (This link will always route to the current Active version of the standard.)

DOI: 10.1520/D5469_D5469M-12

Citation Format

ASTM D5469 / D5469M-12, Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems (Withdrawn 2021), ASTM International, West Conshohocken, PA, 2012, www.astm.org