| Format | Pages | Price |   |
![]() |
3 | $54.00 | ![]() |
Withdrawn Rationale:
This practice describes test conditions and procedures for enclosed carbon-arc exposures conducted according to Practices
Formerly under the jurisdiction of Committee D08 on Roofing and Waterproofing, this practice was withdrawn in January 2013 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1. Scope
1.1 This practice describes test conditions and procedures for enclosed carbon-arc exposures conducted according to Practices G 151 and G 153 for bituminous roofing and waterproofing materials that have a minimum softening point of approximately 95°C (200°F) as determined by Test Method D 36. (See also Terminology G 113.)
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D36 Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)
D1669 Practice for Preparation of Test Panels for Accelerated and Outdoor Weathering of Bituminous Coatings
D1670 Test Method for Failure End Point in Accelerated and Outdoor Weathering of Bituminous Materials
G113 Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials
G141 Guide for Addressing Variability in Exposure Testing of Nonmetallic Materials
G147 Practice for Conditioning and Handling of Nonmetallic Materials for Natural and Artificial Weathering Tests
G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources
G153 Practice for Operating Enclosed Carbon Arc Light Apparatus for Exposure of Nonmetallic Materials
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D0529-04
Citation Format
ASTM D529-04, Standard Practice for Enclosed Carbon-Arc Exposures of Bituminous Materials (Withdrawn 2013), ASTM International, West Conshohocken, PA, 2004, www.astm.org
Back to Top