| ||Format||Pages||Price|| |
|4||$46.00||  ADD TO CART|
|Hardcopy (shipping and handling)||4||$46.00||  ADD TO CART|
|Standard + Redline PDF Bundle||8||$54.00||  ADD TO CART|
This specification defines the size composition and surface preparation requirements for the preparation of test samples used for qualification testing of coatings utilized in nuclear power plant construction and maintenance. All panels should be carbon steel. Materials shall be tested for abrasion, and shall conform to specified requirements of steel samples, and concrete blocks.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Significance and Use
4.1 This specification provides uniform requirements for the preparation of test samples used for testing of coatings and linings to be used in nuclear power plants.
4.2 At the users discretion, this standard may also be used when preparing samples to be tested for the purpose of assessing performance attributes for coating and lining systems that may be applied in other types of power plants or for other industrial facilities.
4.3 Users of this guide must ensure that coatings work complies not only with this guide, but also with the licensee’s plant-specific quality assurance program and licensing commitments.
1.1 This specification defines the size, composition, surface preparation, and coating application variables for preparing samples for evaluating coatings and linings over various substrates.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A36/A36M Specification for Carbon Structural Steel
C33/C33M Specification for Concrete Aggregates
C150/C150M Specification for Portland Cement
C192/C192M Practice for Making and Curing Concrete Test Specimens in the Laboratory
C260 Specification for Air-Entraining Admixtures for Concrete
C494/C494M Specification for Chemical Admixtures for Concrete
C618 Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete
D3912 Test Method for Chemical Resistance of Coatings and Linings for Use in Nuclear Power Plants
D4258 Practice for Surface Cleaning Concrete for Coating
D4259 Practice for Preparation of Concrete by Abrasion Prior to Coating Application
D4260 Practice for Liquid and Gelled Acid Etching of Concrete
D4538 Terminology Relating to Protective Coating and Lining Work for Power Generation Facilities
D4541 Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
D7234 Test Method for Pull-Off Adhesion Strength of Coatings on Concrete Using Portable Pull-Off Adhesion Testers
ICS Number Code 27.120.20 (Nuclear power plants. Safety)
UNSPSC Code 26142106(Nuclear reactor control rod systems)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D5139-19, Standard Specification for Sample Preparation for Qualification Testing of Coatings to be Used in Nuclear Power Plants, ASTM International, West Conshohocken, PA, 2019, www.astm.orgBack to Top