You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM D5033-00

    Standard Guide for Development of ASTM Standards Relating to Recycling and Use of Recycled Plastics (Withdrawn 2007)

    Withdrawn Standard: ASTM D5033-00 | Developed by Subcommittee: D20.95


      Format Pages Price  
    PDF 6 $58.00   ADD TO CART


    Withdrawn Rationale:

    This guide provided information for the development of ASTM standards (guides, practices, terminology, test methods, and specifications) relating to recycling and the use of recycled plastics. Formerly under the jurisdiction of Committee D20 on Plastics, this guide was withdrawn in November 2007 and replaced by Guide D7209 on Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products.

    For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.

    1. Scope

    1.1 This guide provides information for the development of ASTM standards (guides, practices, terminology, test methods, and specifications) relating to recycling and the use of recycled plastics.

    1.2 This guide is directed to consumer, commercial, and industrial products made in whole or in part with recycled plastics or recovered plastic products.

    1.3 This guide addresses terminology, performance standards, specifications and their revisions, quality assurance, separation or segregation of products by classes, identification and labeling of generic classes of polymers, contaminants, fillers, designing for recycling, degradable plastics, and certification and percentages of recycled plastics.

    1.4 This guide does not address general parameters or factors involving the original manufacture of virgin polymers or the fabrication of consumer products from these virgin polymers.

    1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1--There is no equivalent ISO standard.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D5033-00

    Citation Format

    ASTM D5033-00, Standard Guide for Development of ASTM Standards Relating to Recycling and Use of Recycled Plastics (Withdrawn 2007), ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top