If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D4619 - 12(2018)

    Standard Practice for Inspection of Linings in Operating Flue Gas Desulfurization Systems

    Active Standard ASTM D4619 | Developed by Subcommittee: D33.09

    Book of Standards Volume: 06.02

      Format Pages Price  
    PDF 3 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $48.00   ADD TO CART

    Significance and Use

    3.1 Periodic inspections are essential to evaluate lining performance, to detect existing damage potential problems, and to plan scheduled maintenance. The frequency of these inspections may diminish or increase with time depending upon lining performance.

    1. Scope

    1.1 This practice describes procedures for conducting inspections of the conditions of various linings in operating Flue Gas Desulfurization (FGD) system components.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.

    1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C805 Test Method for Rebound Number of Hardened Concrete

    C856 Practice for Petrographic Examination of Hardened Concrete

    D610 Practice for Evaluating Degree of Rusting on Painted Steel Surfaces

    D714 Test Method for Evaluating Degree of Blistering of Paints

    D2240 Test Method for Rubber PropertyDurometer Hardness

    D4541 Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers

    D6677 Test Method for Evaluating Adhesion by Knife

    D7091 Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals

    SSPC Standards

    SSPC-PA 2 Measurement of Dry Paint Thickness with Magnetic Gages

    SSPC-VIS 2

    ICS Code

    ICS Number Code 13.040.01 (Air quality in general)

    UNSPSC Code

    UNSPSC Code 40161607(Flue gas desulphurization system)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D4619-12R18

    Citation Format

    ASTM D4619-12(2018), Standard Practice for Inspection of Linings in Operating Flue Gas Desulfurization Systems, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top