If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D4600 - 95(2016)

    Standard Test Method for Determination of Benzene-Soluble Particulate Matter in Workplace Atmospheres

    Active Standard ASTM D4600 | Developed by Subcommittee: D22.04

    Book of Standards Volume: 11.07

      Format Pages Price  
    PDF 3 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $46.00   ADD TO CART

    Significance and Use

    5.1 This test method provides a means of evaluating exposures to benzene-soluble particulate matter in a concentration range that can be related to occupational exposures.

    1. Scope

    1.1 This test method describes the sampling and gravimetric determination of benzene-soluble particulate matter that has become airborne as a result of certain industrial processes. This test method can be used to determine the total weight of benzene-soluble materials and to provide a sample that may be used for specific and detailed analyses of the soluble components.

    1.2 The limit of detection is 0.05 mg/m3 by sampling a 1-m3 volume of air.

    Note 1: Other volatile organic solvents have been used for this determination and whereas a less toxic solvent for this analysis might be desirable, the substitution of a solvent other than benzene is unwise at this time. A tremendous volume of environmental sampling data based on benzene-soluble determinations has been accumulated over many years in several industries.2 Some of the determinations have been used in epidemiological studies. Furthermore, the use of benzene is specified in existing federal standards.3 As a result, it appears imprudent to use a different solvent until the qualitative and quantitative relationship of analyses derived from benzene and a substitute solvent is established. With proper care, benzene can be safely used in the laboratory.

    1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1356 Terminology Relating to Sampling and Analysis of Atmospheres

    ICS Code

    ICS Number Code 13.040.30 (Workplace atmospheres)

    UNSPSC Code

    UNSPSC Code 77121501(Air quality management)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D4600-95R16

    Citation Format

    ASTM D4600-95(2016), Standard Test Method for Determination of Benzene-Soluble Particulate Matter in Workplace Atmospheres, ASTM International, West Conshohocken, PA, 2016, www.astm.org

    Back to Top