ASTM D4456 - 99(2009)e1

    Standard Test Methods for Physical and Chemical Properties of Powdered Ion Exchange Resins

    Active Standard ASTM D4456 | Developed by Subcommittee: D19.08

    Book of Standards Volume: 11.02

      Format Pages Price  
    PDF 4 $40.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $40.00   ADD TO CART

    Significance and Use

    The particle size distribution of powdered ion exchange resins and, more importantly, the derived parameters of mean particle size and percent above and below specified size limits are useful for determining batch to batch variations and, in some cases, can be related to certain aspects of product performance.

    Although automatic multichannel particle size analyzers, of the type described in Section 9, yield information on the entire distribution of sizes present in a given sample, it has been found that, for this application, the numerical value of three derived parameters may adequately describe the particle size characteristics of the samples: the mean particle diameter (in micrometres), the percent of the sample that falls below some size limit, and the percent of the sample that falls above some size limit.

    1. Scope

    1.1 These test methods cover the determination of the physical and chemical properties of powdered ion exchange resins and are intended for use in testing new materials. The following test methods are included:

    Test Method AParticle Size Distribution 5 to 15
    Test Method BSolids Content16 to 23

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    5.1 This test method covers the instrumental determination of the particle-size distribution of powdered ion exchange resins.

    16.1 This test method covers the determination of the percent solids in new powdered ion exchange resins. Both anion resin and cation resin may be tested by this test method. Resins are tested in the ionic form in which they are received.

    16.2 It is important to note that ion exchange resins, particularly anion exchange resins in the hydroxide form, are subject to thermal degradation under the conditions of this test. Therefore, volatile degradation products are released along with moisture, resulting in a negative error. However, the value of this test method is that it is simple and reproducible, and it is applicable to as-received samples.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1129 Terminology Relating to Water

    D1193 Specification for Reagent Water

    D2687 Practices for Sampling Particulate Ion-Exchange Materials

    D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water



    F658 Practice for Calibration of a Liquid-Borne Particle Counter Using an Optical System Based Upon Light Extinction

    ICS Code

    ICS Number Code 71.100.40 (Surface active agents)

    UNSPSC Code

    UNSPSC Code 13111000(Resins)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D4456-99R09E01

    Citation Format

    ASTM D4456-99(2009)e1, Standard Test Methods for Physical and Chemical Properties of Powdered Ion Exchange Resins, ASTM International, West Conshohocken, PA, 2009,

    Back to Top