ASTM D4333 / D4333M - 18

    Standard Practice for Compatibility of Mechanical Pump Dispenser Components

    Active Standard ASTM D4333 / D4333M | Developed by Subcommittee: F02.30

    Book of Standards Volume: 15.10


      Format Pages Price  
    PDF 3 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $42.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $50.00   ADD TO CART



    Significance and Use

    2.1 This practice identifies the compatibility of the mechanical pump dispenser components with consumer-type products.

    1. Scope

    1.1 This practice covers testing of the components of mechanical pump dispensers (spray or flow types) for compatibility with products.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    ICS Code

    ICS Number Code 55.130 (Aerosol containers)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D4333_D4333M-18

    Citation Format

    ASTM D4333 / D4333M-18, Standard Practice for Compatibility of Mechanical Pump Dispenser Components, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top