| ||Format||Pages||Price|| |
|2||$44.00||  ADD TO CART|
|Hardcopy (shipping and handling)||2||$44.00||  ADD TO CART|
This specification covers coal tar primer suitable for use with coal tar pitch in roofing, dampproofing, and waterproofing below or above ground level, for application to concrete, masonry, and coal tar surfaces. Different tests shall be conducted in order to determine the following physical properties of coal tar primer: water content, consistency, specific gravity, matter insoluble in benzene, distillation, and coke residue content.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers coal tar primer suitable for use with coal tar pitch in roofing, dampproofing, and waterproofing below or above ground level, for application to concrete, masonry, and coal tar surfaces.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D140/D140M Practice for Sampling Asphalt Materials
D168 Test Method for Coke Residue of Creosote
D246 Test Method for Distillation of Creosote and Creosote-Coal Tar Solutions
D347 Tables for Volume and Specific Gravity Correction for Creosote, Creosote-Coal Tar Solution, and Coal Tar
D367 Test Method for Xylene-Insoluble Matter in Creosote
D368 Test Method for Specific Gravity of Creosote and Oil-Type Preservatives
D370 Practice for Dehydration of Oil-Type Preservatives
ICS Number Code 91.100.50 (Binders. Sealing materials)
UNSPSC Code 30121501(Coal tar); 30151500(Roofing materials)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D43 / D43M-00(2018), Standard Specification for Coal Tar Primer Used in Roofing, Dampproofing, and Waterproofing, ASTM International, West Conshohocken, PA, 2018, www.astm.orgBack to Top