| ||Format||Pages||Price|| |
|22||$78.00||  ADD TO CART|
|Hardcopy (shipping and handling)||22||$78.00||  ADD TO CART|
Significance and Use
3.1 These test methods are designed primarily for specimens prepared in a laboratory under standardized conditions such as may be used to provide data for development and control of rubber compounds and methods of manufacture. With slight modifications as indicated, Methods A, B, C, D, and E are also used for obtaining comparative adhesion test values of production parts whenever the design permits preparation of suitable test specimens. Methods A, B, C, and D are applicable in the case of many products in which rubber is used for controlling vibration.
1.1 These test methods cover procedures for testing the static adhesional strength of rubber to rigid materials (in most cases metals).
Method A—Rubber Part Assembled Between Two Parallel Metal Plates.
Method B—90° Stripping Test—Rubber Part Assembled to One Metal Plate.
Method C—Measuring Adhesion of Rubber to Metal with a Conical Specimen.
Method D—Adhesion Test—Post-Vulcanization (PV) Bonding of Rubber to Metal.
Method E—90° Stripping Test—Rubber Tank Lining—Assembled to One Metal Plate.
Method F—Rubber Part Assembled Between Two Parallel Convex-Shaped Metal Plates
Method G—Measuring Bond Durability for Rubber-to-Metal Bonded Components with a Double Shear Cylindrical Specimen
Method H—Measuring Bond Durability for Rubber-to-Metal Bonded Components with a Quadruple Shear Specimen
1.2 While the test method may be used with a wide variety of rigid materials, use of materials other than metals is the exception. For this reason, we have used the word “metal” in the text rather than “rigid materials.”
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B117 Practice for Operating Salt Spray (Fog) Apparatus
D395 Test Methods for Rubber PropertyCompression Set
D412 Test Methods for Vulcanized Rubber and Thermoplastic ElastomersTension
D471 Test Method for Rubber PropertyEffect of Liquids
D572 Test Method for RubberDeterioration by Heat and Oxygen
D573 Test Method for RubberDeterioration in an Air Oven
D1149 Test Methods for Rubber DeteriorationCracking in an Ozone Controlled Environment
E4 Practices for Force Verification of Testing Machines
G153 Practice for Operating Enclosed Carbon Arc Light Apparatus for Exposure of Nonmetallic Materials
ICS Number Code 83.060 (Rubber)
UNSPSC Code 13100000(Rubber and elastomers)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D429-14e1, Standard Test Methods for Rubber Property—Adhesion to Rigid Substrates, ASTM International, West Conshohocken, PA, 2014, www.astm.orgBack to Top