If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D3889 / D3889M - 96(2020)

    Standard Test Method for Adherence to Linerboard of Pressure-Sensitive Tape at Low Temperature

    Active Standard ASTM D3889 / D3889M | Developed by Subcommittee: D10.14

    Book of Standards Volume: 15.10

      Format Pages Price  
    PDF 3 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $46.00   ADD TO CART

    Significance and Use

    5.1 Satisfactory tape performance at the test temperature implies satisfactory cold-temperature performance at or above the test temperature.

    5.2 This procedure would be applicable for questions of adherence to 100 % kraft fiberboards similar to the standard linerboard surface without substitution but for direct information on any board or surface, the actual surface in question should be substituted.

    1. Scope

    1.1 This test method covers one procedure for determining the adherence of pressure-sensitive tapes to a standard linerboard or other similar surface.

    1.2 This test method provides for an attribute response (pass or fail) and does not yield numerical data on a variable or continuous scale.

    1.3 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently without combining values in any way.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D996 Terminology of Packaging and Distribution Environments

    D3715/D3715M Practice for Quality Assurance of Pressure-Sensitive Tapes

    D4332 Practice for Conditioning Containers, Packages, or Packaging Components for Testing

    E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process

    ICS Code

    ICS Number Code 55.040 (Packaging materials and accessories)

    UNSPSC Code

    UNSPSC Code 31201626(Pressure sensitive adhesive PSA)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3889_D3889M-96R20

    Citation Format

    ASTM D3889 / D3889M-96(2020), Standard Test Method for Adherence to Linerboard of Pressure-Sensitive Tape at Low Temperature, ASTM International, West Conshohocken, PA, 2020, www.astm.org

    Back to Top