| ||Format||Pages||Price|| |
|2||$40.00||  ADD TO CART|
|Hardcopy (shipping and handling)||2||$40.00||  ADD TO CART|
Significance and Use
4.1 This practice provides a guide whereby all pertinent variables relating to the ultraviolet cure of a coating are described.
1.1 This practice applies to all coatings cured by ultraviolet energy.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D658 Test Method for Abrasion Resistance of Organic Coatings by Air Blast Abrasive
D968 Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive
D1474 Test Methods for Indentation Hardness of Organic Coatings
D2197 Test Method for Adhesion of Organic Coatings by Scrape Adhesion
D2336 Guide for Specifying Factory Applied Wood Coatings
D2793 Test Method for Block Resistance of Organic Coatings on Wood Panel Substrates
D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)
D3023 Practice for Determination of Resistance of Factory-Applied Coatings on Wood Products to Stains and Reagents
D3281 Test Method for Formability of Attached Organic Coatings with Impact-Wedge Bend Apparatus
D3359 Test Methods for Measuring Adhesion by Tape Test
D3363 Test Method for Film Hardness by Pencil Test
ICS Number Code 87.040 (Paints and varnishes)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D3732-82(2017), Standard Practice for Reporting Cure Times of Ultraviolet-Cured Coatings, ASTM International, West Conshohocken, PA, 2017, www.astm.orgBack to Top