| Format | Pages | Price |   |
![]() |
3 | $42.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 3 | $42.00 | ![]() |
Historical Version(s) - view previous versions of standard
More D13.54 Standards Related Products Standard References
Abstract
This specification establishes standard dimensions for zippers of all materials for specified size designation; for equivalency, in inch-pound and metric units, of zipper length and length tolerances, of tape width and width tolerances, and of tape end lengths. Size, zipper length, tape width, and tape end length tests shall be performed in accordance with the specified requirements.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification establishes standard dimensions for zippers of all materials for specified size designation; for equivalency, in inch-pound and metric units, of zipper length and length tolerances, of tape width and width tolerances, and of tape end lengths.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D2050 Terminology Relating to Fasteners and Closures Used with Textiles
D2060 Test Methods for Measuring Zipper Dimensions
ICS Code
ICS Number Code 61.040 (Headgear. Clothing accessories. Fastening of clothing)
UNSPSC Code
UNSPSC Code 53141503(Zippers)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D3657-03R14
Citation Format
ASTM D3657-03(2014), Standard Specification for Zipper Dimensions, ASTM International, West Conshohocken, PA, 2014, www.astm.org
Back to Top