| Format | Pages | Price |   |
![]() |
2 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 2 | $46.00 | ![]() |
Historical Version(s) - view previous versions of standard
More D01.35 Standards Related Products Standard References
Abstract
This specification establishes the properties and requirements for ethyl acrylate for use in paint, varnish, lacquer, and related products. Specimens shall be sampled, undergo chemical tests, and conform accordingly to purity, water content, color, acidity, and methyl ether of hydroquinone content requirements.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers ethyl acrylate (99 % grade) for use in paint, varnish, lacquer, and related products.
1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 For specification hazard information and guidance, see the supplier’s Safety Data Sheet for materials listed in this specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 4.1.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1209 Test Method for Color of Clear Liquids (Platinum-Cobalt Scale)
D1364 Test Method for Water in Volatile Solvents (Karl Fischer Reagent Titration Method)
D1613 Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
D3125 Test Method for Monomethyl Ether of Hydroquinone in Colorless Monomeric Acrylate Esters and Acrylic Acid
D3362 Test Method for Purity of Acrylate Esters by Gas Chromatography
D5386 Test Method for Color of Liquids Using Tristimulus Colorimetry
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E300 Practice for Sampling Industrial Chemicals
ICS Code
ICS Number Code 83.080.20 (Thermoplastic materials)
UNSPSC Code
UNSPSC Code 12352108(Esters or its substitutes)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D3548-09R17
Citation Format
ASTM D3548-09(2017), Standard Specification for Ethyl Acrylate, ASTM International, West Conshohocken, PA, 2017, www.astm.org
Back to Top