If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D3474 - 90(2018)

    Standard Practice for Calibration and Use of Torque Meters Used in Packaging Applications

    Active Standard ASTM D3474 | Developed by Subcommittee: F02.25

    Book of Standards Volume: 15.10

      Format Pages Price  
    PDF 3 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $48.00   ADD TO CART

    Significance and Use

    5.1 This practice can be used to check devices used to measure the application and removal torques of continuous or intermittent thread and lug closures.

    5.2 This practice can be used to determine the amount of torque to either apply or remove a closure.

    1. Scope

    1.1 This practice covers the calibration and use of torque meters of the type normally used in packaging applications.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3198 Test Method for Application and Removal Torque of Threaded or Lug-Style Closures

    ICS Code

    ICS Number Code 55.200 (Packaging machinery)

    UNSPSC Code

    UNSPSC Code 23152900(Packaging machinery)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3474-90R18

    Citation Format

    ASTM D3474-90(2018), Standard Practice for Calibration and Use of Torque Meters Used in Packaging Applications, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top