ASTM D3409 / D3409M - 93(2016)e1
Standard Test Method for Adhesion of Asphalt-Roof Cement to Damp, Wet, or Underwater Surfaces
| Format | Pages | Price | ||
 |
2 | $41.00 |  ADD TO CART |
|
 |
Hardcopy (shipping and handling) | 2 | $41.00 | ADD TO CART |
Historical Version(s) - view previous versions of standard
More D08.05 Standards Related Products Standard References Reprints and Permissions
Significance and Use
3.1 This test method offers a means of evaluating the adhesive properties of asphalt roofing cements used to repair roofs under adverse conditions. Weathered roof surfaces are easily coated with asphalt roofing cements when they are dry, however when wet or during a rain, asphalt roofing cements may not adhere readily to water-wet surfaces such as metal flashings or asphalt roll roofing. The flamed metal lids used in this test method simulate weathered roof surfaces.
1. Scope
1.1 This test method covers the determination of the adhesion of asphalt roofing cements to damp, wet, or underwater surfaces.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ICS Code
ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
UNSPSC Code
UNSPSC Code 30121601(Asphalt); 30151500(Roofing materials)
Referencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D3409_D3409M-93R16E01
Citation Format
ASTM D3409 / D3409M-93(2016)e1, Standard Test Method for Adhesion of Asphalt-Roof Cement to Damp, Wet, or Underwater Surfaces, ASTM International, West Conshohocken, PA, 2016, www.astm.org
Back to Top