ASTM D3366 - 18

    Standard Test Method for Color of Maleic Anhydride in the Molten State and After Heating (Platinum-Cobalt Scale)

    Active Standard ASTM D3366 | Developed by Subcommittee: D16.02

    Book of Standards Volume: 06.04


      Format Pages Price  
    PDF 4 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $42.00   ADD TO CART



    Significance and Use

    4.1 The color of maleic anhydride can be an indication of the purity of these materials. High colors normally indicate contamination or decomposition. This test method is suitable for setting specifications and for use as an internal quality control tool.

    1. Scope

    1.1 This test method covers the determination of the visual measurement of the color of maleic anhydride melt before and after prolonged heating under specified conditions of time and temperature. Color values are expressed in terms of platinum-cobalt standards.

    1.2 This test method covers the range 0 to 100 color standard numbers.

    1.3 In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29.

    1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Sections 7, 10.2.1, and 10.4.2.

    1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    D1209 Test Method for Color of Clear Liquids (Platinum-Cobalt Scale)

    D1686 Test Method for Color of Solid Aromatic Hydrocarbons and Related Materials in the Molten State (Platinum-Cobalt Scale)

    D3438 Practice for Sampling and Handling Naphthalene, Maleic Anhydride, and Phthalic Anhydride

    D6809 Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials

    D8005 Test Method for Color of Clear Liquids (Platinum-Cobalt Scale)

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 71.080.50 (Anhydrides)

    UNSPSC Code

    UNSPSC Code 12352106(Organic acids or its substitutes)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3366-18

    Citation Format

    ASTM D3366-18, Standard Test Method for Color of Maleic Anhydride in the Molten State and After Heating (Platinum-Cobalt Scale), ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top