You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D2569-97(2002)e1

    Standard Test Method for Distillation of Pitch (Withdrawn 2006)

    Withdrawn Standard: ASTM D2569-97(2002)e1 | Developed by Subcommittee: D02.05.0F


      Format Pages Price  
    PDF 4 $56.00   ADD TO CART


    Withdrawn Rationale:

    This test method covers a distillation test for pitch applicable whenever the amount of distillate below 270C is less than 2.0 % by this test method.

    This test method is being withdrawn due to poor precision and a very broad repeatability and reproducibility.

    Formerly under the jurisdiction of Committee D02 on Petroleum Products and Lubricants, this test method was withdrawn without replacement in August 2006.

    1. Scope

    1.1 This test method covers a distillation test for pitch applicable whenever the amount of distillate below 270°C is less than 2.0% by this test method.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2569-97R02E01

    Citation Format

    ASTM D2569-97(2002)e1, Standard Test Method for Distillation of Pitch (Withdrawn 2006), ASTM International, West Conshohocken, PA, 1997, www.astm.org

    Back to Top