| Format | Pages | Price |   |
![]() |
6 | $52.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 6 | $52.00 | ![]() |
Historical Version(s) - view previous versions of standard
More D20.18 Standards Related Products Standard References
Abstract
This practice covers acceptance criteria for visual inspection of parts molded from reinforced thermosetting plastics by compression and transfer molding. Word descriptions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection are presented. Different inspection requirements for grades of product quality are categorized. Each part shall be checked visually without the aid of magnification. Defects shall be classified as to type and level as prescribed.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This practice covers acceptance criteria for visual inspection of parts molded from reinforced thermosetting plastics by compression and transfer molding.
1.2 This practice presents word descriptions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection.
1.3 This practice also categorizes different inspection requirements for grades of product quality.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
ICS Code
ICS Number Code 83.120 (Reinforced plastics)
UNSPSC Code
UNSPSC Code 13101900(Thermoset plastics)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D2562-94R15
Citation Format
ASTM D2562-94(2015), Standard Practice for Classifying Visual Defects in Parts Molded from Reinforced Thermosetting Plastics, ASTM International, West Conshohocken, PA, 2015, www.astm.org
Back to Top