| Format | Pages | Price |   |
![]() |
2 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 2 | $46.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
4 | $54.00 | ![]() |
Historical Version(s) - view previous versions of standard
Work Item(s) - proposed revisions of this standard
More D02.L0.05 Standards Related Products Standard References
Significance and Use
5.1 Solid lubricant coatings are applied to surfaces that are exposed to heat and cold to such a degree that in many cases liquid lubricants are not practical. Adherence under these conditions is mandatory to preserve the bearing surfaces during sliding motion.
1. Scope
1.1 This test method covers the measurement of the resistance of dry solid film lubricants to deterioration when subjected to temperature extremes.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
U.S. Federal Specification
P-D-680 Dry Cleaning Solvent Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098.ASTM Standards
A167 Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip
D2510 Test Method for Adhesion of Solid Film Lubricants
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
UNSPSC Code
UNSPSC Code 15121500(Lubricating preparations)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D2511-20
Citation Format
ASTM D2511-20, Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants, ASTM International, West Conshohocken, PA, 2020, www.astm.org
Back to Top