ASTM D2449 - 88(2015)

    Standard Specification for Rubber Bales From Natural Sources—Limit on Coating

    Active Standard ASTM D2449 | Developed by Subcommittee: D11.22

    Book of Standards Volume: 09.01

      Format Pages Price  
    PDF 2 $44.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $44.00   ADD TO CART


    This specification covers bale coatings on rubber bales made from natural sources. This is not applicable to natural rubbers packaged with plastic wrappers. Samples for testing should be carefully collected at random from the outside of the wrapper sheets from any three sides of the bale and properly handled and stored. Test methods include an ashing procedure to determine the amount of mineral filler from the bale coating on the wrapper sheets. A brushing or scraping procedure is also detailed for determining the amount of bale coating in the outside of the wrapper sheets of smoked sheet rubbers only.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers bale coating on bales of natural rubber (that have rubber wrapper sheets on the bales) and includes test method description. It specifies the maximum permissible amount of such coating.

    1.2 This specification is not applicable to natural rubber that is packaged with plastic wrappers, as no bale coating is used.

    1.3 The following safety hazards caveat pertains only to the test method portion, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1278 Test Methods for Rubber from Natural SourcesChemical Analysis

    D1485 Practice for Rubber from Natural SourcesSampling and Sample Preparation

    ICS Code

    ICS Number Code 83.040.10 (Latex and raw rubber)

    UNSPSC Code

    UNSPSC Code 13101500(Natural rubber)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2449-88R15

    Citation Format

    ASTM D2449-88(2015), Standard Specification for Rubber Bales From Natural Sources—Limit on Coating, ASTM International, West Conshohocken, PA, 2015,

    Back to Top