| ||Format||Pages||Price|| |
|2||$52.00||  ADD TO CART|
This test method covers the procedure for the quantitative separation of the vehicle from the pigment in solvent-reducible coatings.
Formerly under the jurisdiction of Committee D01 on Paint and Related Coatings, Materials, and Applications, this test method was withdrawn in July 2019 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method covers the procedure for the quantitative separation of the vehicle from the pigment in solvent-reducible coatings.
1.2 This test method has been proven to be applicable to the following types of paints: white linseed oil outside house paint, white soya and phthalic alkyd enamel, white linseed o-phthalic alkyd enamel, red lead primer, zinc chromate primer, flat white inside enamel, white epoxy enamel, white vinyl toluene modified alkyd, and white amino modified baking enamel. It is considered to be applicable to most solvent-reducible paints.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 6.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D2698 Test Method for Determination of the Pigment Content of Solvent-Reducible Paints by High-Speed Centrifuging
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D2371-85(2010), Standard Test Method for Pigment Content of Solvent-Reducible Paints (Withdrawn 2019), ASTM International, West Conshohocken, PA, 2010, www.astm.orgBack to Top