| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$48.00||  ADD TO CART|
Significance and Use
4.1 Acidic fluorides are undesirable in SF6 used as an electrical insulating gas in that they may contribute to corrosion or constitute dielectric hazard.
4.2 This test method is valid for both new and used SF6. In used SF6, it will only measure those active species which are hydrolyzable.
1.1 This test method covers the determination of the acidic fluorides of sulfur hexafluoride (SF6).
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1193 Specification for Reagent Water
ICS Number Code 71.060.50 (Salts)
UNSPSC Code 12352300(Inorganic compounds)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D2284-11(2019), Standard Test Method for Acidity of Sulfur Hexafluoride, ASTM International, West Conshohocken, PA, 2019, www.astm.orgBack to Top