ASTM D1900 - 20

    Standard Practice for Carbon Black—Sampling Bulk Shipments

    Active Standard ASTM D1900 | Developed by Subcommittee: D24.61

    Book of Standards Volume: 09.01

      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART
    Standard + Redline PDF Bundle 4 $54.00   ADD TO CART

    Significance and Use

    3.1 Sampling of bulk shipments of carbon blacks is of utmost importance since the location and number of samples taken by different laboratories can have a significant effect on the agreement of test values obtained. This practice is for use in obtaining representative samples of carbon black in each compartment or in the entire hopper car or hopper truck. These samples may be used to ascertain the average quality or the uniformity of a shipment, or both.

    1. Scope

    1.1 This practice covers procedures for the sampling and data reporting of bulk shipments of carbon black in three-compartment hopper rail cars and compartmented bulk hopper trailers.

    Note 1: The tests to be made on the samples obtained by this practice, how many samples are taken, where they are taken, and what statistical values (if any) to report shall be determined by agreement between the purchaser and the manufacturer. This practice gives guidance for use in developing such agreements or for use when no formal agreement exists. The specific details of each procedure are described in appropriate ASTM test methods used for testing carbon black.

    Note 2: Some purchasers or manufacturers may consider Flexible Intermediate Bulk Containers (FIBC) to be a bulk shipment. See Practice D1799 for guidance on sampling and reporting for this package.

    1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1509 Test Methods for Carbon BlackHeating Loss

    D1799 Practice for Carbon BlackSampling Packaged Shipments

    D5817 Practice for Carbon Black, PelletedReduction, Blending, and Drying of Gross Samples for Testing

    ICS Code

    ICS Number Code 83.040.20 (Rubber compounding ingredients)

    UNSPSC Code

    UNSPSC Code 12171603(Carbon black)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1900-20

    Citation Format

    ASTM D1900-20, Standard Practice for Carbon Black—Sampling Bulk Shipments, ASTM International, West Conshohocken, PA, 2020,

    Back to Top