ASTM D1831 - 18

    Standard Test Method for Roll Stability of Lubricating Grease

    Active Standard ASTM D1831 | Developed by Subcommittee: D02.G0.02

    Book of Standards Volume: 05.01


      Format Pages Price  
    PDF 3 $41.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $41.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $49.20   ADD TO CART



    Significance and Use

    5.1 The roll stability test is widely used in specifications. Test results are significant insofar as they can show a directional change in consistency that could occur in service. No accurate correlation is established between the test results and shear stability in actual service.

    1. Scope

    1.1 This test method covers determination of the changes in the consistency, as measured by cone penetration, of lubricating greases when worked in the roll stability test apparatus.

    1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D217 Test Methods for Cone Penetration of Lubricating Grease

    D1403 Test Methods for Cone Penetration of Lubricating Grease Using One-Quarter and One-Half Scale Cone Equipment

    D4175 Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants


    ICS Code

    ICS Number Code 75.100 (Lubricants, industrial oils and related products)

    UNSPSC Code

    UNSPSC Code 15121902(Grease)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1831-18

    Citation Format

    ASTM D1831-18, Standard Test Method for Roll Stability of Lubricating Grease, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top