| Format | Pages | Price |   |
![]() |
5 | $62.00 | ![]() |
Translated Version(s):
Russian
Withdrawn Rationale:
This test method covers the determination of water in the concentration from 50 to 1000 mg/kg in liquid petroleum products.
Formerly under the jurisdiction of Committee D02 on Petroleum Products, Liquid Fuels, and Lubricants, this test method was withdrawn in April 2016 because it is out of date and has not been revised.
1. Scope
1.1 This test method covers the determination of water in the concentration from 50 to 1000 mg/kg in liquid petroleum products.
1.2 Values stated in SI units are to be regarded as the standard. Inch-pound units are provided for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section 7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D1744-13
Citation Format
ASTM D1744-13, Standard Test Method for Determination of Water in Liquid Petroleum Products by Karl Fischer Reagent (Withdrawn 2016), ASTM International, West Conshohocken, PA, 2013, www.astm.org
Back to Top