| ||Format||Pages||Price|| |
|2||$56.00||  ADD TO CART|
This test method covers a procedure for detecting the presence of acetone in methanol in amounts greater than 0.003 weight %.
Formerly under the jurisdiction of Committee D01 on Paint and Related Coatings, Materials and Applications, this test method was withdrawn in June 2011 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method covers a procedure for detecting the presence of acetone in methanol in amounts greater than 0.003 weight %.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 For hazard information and guidance, see the supplier's Material Safety Data Sheet.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1193 Specification for Reagent Water
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D1612-05, Standard Test Method for Acetone in Methanol (Withdrawn 2011), ASTM International, West Conshohocken, PA, 2005, www.astm.orgBack to Top