If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D1596 - 14

    Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material

    Active Standard ASTM D1596 | Developed by Subcommittee: D10.13

    Book of Standards Volume: 15.10

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $48.00   ADD TO CART
    Standard + Redline PDF Bundle 8 $56.00   ADD TO CART

    Significance and Use

    5.1 Dynamic cushioning test data obtained by this test method are applicable to the cushioning material and not necessarily the same as obtained in a package. In addition to the influence of the package, the data can also be affected by the specimen area, thickness, loading rate, and other factors.

    1. Scope

    1.1 This test method covers a procedure for obtaining dynamic shock cushioning characteristics of packaging materials through acceleration-time data achieved from dropping a falling guided platen assembly onto a motionless sample. This test method does not address any effects or contributions of exterior packaging assemblies.

    1.2 The data acquired may be used for a single point or for use in developing a dynamic cushion curve for the specific material being tested. Such data may be used for comparison among different materials at specific input conditions, or qualifying materials against performance specifications. Caution should be used when attempting to compare data from different methods or when using such data for predicting in-package performance. Depending upon the particular materials of concern, correlation of such data (from among differing procedures or for predicting in–package performance) may be highly variable.

    Note 1Alternative and related method for possible consideration is Test Method D4168.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D996 Terminology of Packaging and Distribution Environments

    D4168 Test Methods for Transmitted Shock Characteristics of Foam-in-Place Cushioning Materials

    D4332 Practice for Conditioning Containers, Packages, or Packaging Components for Testing

    E105 Practice for Probability Sampling of Materials

    E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process

    ICS Code

    ICS Number Code 55.040 (Packaging materials and accessories)

    UNSPSC Code

    UNSPSC Code 24141603(Cushioning)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1596-14

    Citation Format

    ASTM D1596-14, Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top