If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
ASTM D1045 - 19
Standard Test Methods for Sampling and Testing Plasticizers Used in Plastics
| Format | Pages | Price | ||
 |
4 | $46.00 |  ADD TO CART |
|
 |
Hardcopy (shipping and handling) | 4 | $46.00 | ADD TO CART |
|
Standard + Redline PDF Bundle  |
8 | $54.00 | ADD TO CART |
Historical Version(s) - view previous versions of standard
More D20.15 Standards Related Products Standard References
Significance and Use
4.1 These test methods shall be used in establishing and confirming quality control standards for liquid plasticizers used in the compounding of plastics.
1. Scope
1.1 These test methods cover sampling and testing of liquid plasticizers used in compounding of plastics. Acid number, ester content, specific gravity, color, refractive index, and water content are determined.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazards information is given in Section 5.
Note 1: There is no known ISO equivalent to this standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D70 Test Method for Density of Semi-Solid Asphalt Binder (Pycnometer Method)
D287 Test Method for API Gravity of Crude Petroleum and Petroleum Products (Hydrometer Method)
D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
D883 Terminology Relating to Plastics
D1193 Specification for Reagent Water
D1209 Test Method for Color of Clear Liquids (Platinum-Cobalt Scale)
D1218 Test Method for Refractive Index and Refractive Dispersion of Hydrocarbon Liquids
D1544 Test Method for Color of Transparent Liquids (Gardner Color Scale)
D1600 Terminology for Abbreviated Terms Relating to Plastics
D3465 Test Method for Purity of Monomeric Plasticizers by Gas Chromatography
D4052 Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter
D5386 Test Method for Color of Liquids Using Tristimulus Colorimetry
E1 Specification for ASTM Liquid-in-Glass Thermometers
E203 Test Method for Water Using Volumetric Karl Fischer Titration
E2251 Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids
ICS Code
ICS Number Code 83.040.30 (Auxiliary materials and additives for plastics)
UNSPSC Code
UNSPSC Code 12162000(Plasticizers)
Referencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D1045-19
Citation Format
ASTM D1045-19, Standard Test Methods for Sampling and Testing Plasticizers Used in Plastics, ASTM International, West Conshohocken, PA, 2019, www.astm.org
Back to Top