| ||Format||Pages||Price|| |
|3||$41.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$41.00||  ADD TO CART|
|Standard + Redline PDF Bundle||6||$49.20||  ADD TO CART|
This specification covers the structural design and quality control of fabrication for load-bearing and non-load-bearing prefabricated masonry panels. Structural design of panels shall be performed in accordance with the provisions of the applicable local building code and the requirements specified. A quality control test shall be made in accordance with the specified requirements.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers the structural design and quality control of fabrication for load-bearing and non-load-bearing prefabricated masonry panels. Methods of prefabrication, field erection, and jointing are not covered in this specification.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other StandardsTMS402 Building Code Requirements for Masonry Structures Available from The Masonry Society, 105 South Sunset Street, Suite Q, Longmont, CO 80501-6172, http://www.masonrysociety.org.
C67 Test Methods for Sampling and Testing Brick and Structural Clay Tile
C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
C140 Test Methods for Sampling and Testing Concrete Masonry Units and Related Units
C270 Specification for Mortar for Unit Masonry
C476 Specification for Grout for Masonry
C780 Test Method for Preconstruction and Construction Evaluation of Mortars for Plain and Reinforced Unit Masonry
C1019 Test Method for Sampling and Testing Grout
C1180 Terminology of Mortar and Grout for Unit Masonry
C1232 Terminology for Masonry
C1314 Test Method for Compressive Strength of Masonry Prisms
C1357 Test Methods for Evaluating Masonry Bond Strength
C1717 Test Methods for Conducting Strength Tests of Masonry Wall Panels
E518 Test Methods for Flexural Bond Strength of Masonry
ICS Number Code 91.060.10 (Walls. Partitions. Facades)
UNSPSC Code 30161505(Panels or paneling)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C901-18, Standard Specification for Prefabricated Masonry Panels, ASTM International, West Conshohocken, PA, 2018, www.astm.orgBack to Top