| ||Format||Pages||Price|| |
|2||$44.00||  ADD TO CART|
|Hardcopy (shipping and handling)||2||$44.00||  ADD TO CART|
This specification covers the material characteristics, physical requirements, and sampling method appropriate to the selection of granite dimension stone for general building and structural purposes. Granite dimension stone shall include stone that is sawed, cut, split, or otherwise finished or shaped, and shall specifically exclude molded, cast, or otherwise artificially aggregated units composed of fragments, crushed and broken stone. Granite stones covered here shall be used for: exterior and interior cladding of buildings and structures; curbstone, paving, and landscape features; structural components having established dimensions; grade separations and retaining walls; and monuments. The physical property requirements to which granite stones shall adhere to are absorption by weight, density, compressive weight, modulus of rupture, abrasion resistance, and flexural strength.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers the material characteristics, physical requirements, and sampling appropriate to the selection of granite for general building and structural purposes. Refer to Guides and for the appropriate selection and use of granite dimension stone.
1.2 Granite dimension stone shall include stone that is sawed, cut, split, or otherwise finished or shaped, and shall specifically exclude molded, cast, or otherwise artificially aggregated units composed of fragments, crushed and broken stone.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C97/C97M Test Methods for Absorption and Bulk Specific Gravity of Dimension Stone
C99/C99M Test Method for Modulus of Rupture of Dimension Stone
C119 Terminology Relating to Dimension Stone
C170/C170M Test Method for Compressive Strength of Dimension Stone
C241/C241M Test Method for Abrasion Resistance of Stone Subjected to Foot Traffic
C880/C880M Test Method for Flexural Strength of Dimension Stone
C1242 Guide for Selection, Design, and Installation of Dimension Stone Attachment Systems
C1353 Test Method for Abrasion Resistance of Dimension Stone Subjected to Foot Traffic Using a Rotary Platform Abraser
C1528 Guide for Selection of Dimension Stone
ICS Number Code 91.100.15 (Mineral materials and products)
UNSPSC Code 11111604(Granite)
UNSPSC Code 11111600(Stone)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C615 / C615M-18e1, Standard Specification for Granite Dimension Stone, ASTM International, West Conshohocken, PA, 2018, www.astm.orgBack to Top