Standard Historical Last Updated: Jan 31, 2012 Track Document
ASTM C428-05(2006)

Standard Specification for Asbestos-Cement Nonpressure Sewer Pipe

Standard Specification for Asbestos-Cement Nonpressure Sewer Pipe C0428-05R06 ASTM|C0428-05R06|en-US Standard Specification for Asbestos-Cement Nonpressure Sewer Pipe Standard new BOS Vol. 04.05 Committee C17
$ 75.00 In stock

Abstract

This specification covers requirements relating to asbestos-cement nonpressure sewer pipes, joints, and fittings suitable for use with gravity flow, intended for sewerage and drainage applications from point of use to point of treatment or disposal. It defines certain conditions of manufacture, classification, characteristics, and acceptance tests applicable to these products. Asbestos-cement pipe furnished under this specification shall be designated as Classes 1500, 2400, 3300, 4000, 5000, 6000, and 7000 based on the respective crushing strengths, and shall be furnished in the designated sizes. The pipes shall also be classified in two types (I and II) in accordance with the amount of uncombined calcium hydroxide. Materials shall be sampled, tested, and conform accordingly to the following physical requirements: crushing strength, flexural strength, joint tightness, straight alignment, maximum deflected position, and dimensions.

Scope

1.1 This specification covers requirements relating to asbestos-cement nonpressure sewer pipe, joints, and fittings suitable for use with gravity flow, intended for sewerage and drainage applications from point of use to point of treatment or disposal. It defines certain conditions of manufacture, classification, characteristics, and acceptance tests applicable to these products.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.

Note 1—Rubber rings suitable for use with this pipe are covered in Specification D 1869.

Note 2—As general guidance to achieve safe and clean construction-site conditions when working with asbestos-cement pipe products, the procedures covered in AWWA No. M-16 shall be followed.

Note 3—This specification is issued for product standardization and purchasing purposes only, and does not include requirements for installation or the relationships between operating conditions and the strength characteristics of the various classifications of pipe. The purchaser is cautioned that he must correlate installation and operating conditions with the specified characteristics of the pipe.

1.3 Warning—Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products minimize the dust that results. For information on the safe use of chrysoltile asbestos, refer to "Safe Use of Chrysotile: A Manual on Preventive and Control Measures."

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.For a specific safety hazard, see 1.3.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.05
Developed by Subcommittee: C17.03
Pages: 5
DOI: 10.1520/C0428-05R06
ICS Code: 23.040.50