| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$48.00||  ADD TO CART|
This specification covers perlite, vermiculite, natural and manufactured sand for use as gypsum plaster aggregates. The materials shall conform to the chemical composition, grading, and density requirements covered in this specification. The materials shall be tested for sieve analysis, density of lightweight aggregate, and water soluble impurities of sand.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers perlite, vermiculite, natural and manufactured sand for use as gypsum plaster aggregates.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C11 Terminology Relating to Gypsum and Related Building Materials and Systems
C29/C29M Test Method for Bulk Density (Unit Weight) and Voids in Aggregate
C40/C40M Test Method for Organic Impurities in Fine Aggregates for Concrete
C136/C136M Test Method for Sieve Analysis of Fine and Coarse Aggregates
C471M Test Methods for Chemical Analysis of Gypsum and Gypsum Products (Metric)
D75/D75M Practice for Sampling Aggregates
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
UNSPSC Code 30111701(Gypsum plaster); 30111800(Aggregates)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C35-01(2019), Standard Specification for Inorganic Aggregates for Use in Gypsum Plaster, ASTM International, West Conshohocken, PA, 2019, www.astm.orgBack to Top