| ||Format||Pages||Price|| |
|3||$42.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$42.00||  ADD TO CART|
|Standard + Redline PDF Bundle||6||$50.00||  ADD TO CART|
Significance and Use
4.1 These methods offer a means of estimating the working time, initial setting time and service strength setting time of chemical-resistant resin mortars. The results obtained should serve as a guide in, but not as the sole basis for, selection of a chemical-resistant mortar for a particular application.
1.1 These methods are used to estimate the working, initial setting, and service strength setting times of chemical-resistant resin mortars.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C279 Specification for Chemical-Resistant Masonry Units
C307 Test Method for Tensile Strength of Chemical-Resistant Mortar, Grouts, and Monolithic Surfacings
C904 Terminology Relating to Chemical-Resistant Nonmetallic Materials
ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
UNSPSC Code 30111500(Concrete and mortars)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C308-18, Standard Practice for Working, Initial Setting, and Service Strength Setting Times of Chemical-Resistant Resin Mortars, ASTM International, West Conshohocken, PA, 2018, www.astm.orgBack to Top