| ||Format||Pages||Price|| |
|7||$60.00||  ADD TO CART|
This test method covered chemical determination of the potential reactivity of an aggregate with alkalies in portland-cement concrete as indicated by the amount of reaction during 24 h at 80 °C between 1 N sodium hydroxide solution and aggregate that has been crushed and sieved.
Formerly under the jurisdiction of Committee C09 on Concrete and Concrete Aggregates, this test method was withdrawn in January 2016 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method covers chemical determination of the potential reactivity of an aggregate with alkalies in portland-cement concrete as indicated by the amount of reaction during 24 h at 80 ° C between 1 N sodium hydroxide solution and aggregate that has been crushed and sieved to pass a 300-m sieve and be retained on a 150-m sieve.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement is given in 5.7.1.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C114 Test Methods for Chemical Analysis of Hydraulic Cement
C227 Test Method for Potential Alkali Reactivity of Cement-Aggregate Combinations (Mortar-Bar Method)
C295 Guide for Petrographic Examination of Aggregates for Concrete
C702 Practice for Reducing Samples of Aggregate to Testing Size
C1005 Specification for Reference Masses and Devices for Determining Mass and Volume for Use in the Physical Testing of Hydraulic Cements
C1260 Test Method for Potential Alkali Reactivity of Aggregates (Mortar-Bar Method)
C1293 Test Method for Determination of Length Change of Concrete Due to Alkali-Silica Reaction
D75 Practice for Sampling Aggregates
D1193 Specification for Reagent Water
D1248 Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
E60 Practice for Analysis of Metals, Ores, and Related Materials by Spectrophotometry
American Chemical Society DocumentsReagent Chemicals, American Chemical Society Speci
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C289-07, Standard Test Method for Potential Alkali-Silica Reactivity of Aggregates (Chemical Method) (Withdrawn 2016), ASTM International, West Conshohocken, PA, 2007, www.astm.orgBack to Top