ASTM C225 - 85(2014)

    Standard Test Methods for Resistance of Glass Containers to Chemical Attack

    Active Standard ASTM C225 | Developed by Subcommittee: C14.02

    Book of Standards Volume: 15.02

      Format Pages Price  
    PDF 7 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 7 $52.00   ADD TO CART

    Significance and Use

    3.1 The solubility of glass in contact with food, beverages, or pharmaceutical products is an important consideration for the safe packaging and storage of such materials. Autoclave conditions are specified since sterilization is often employed for the packaging of the product. It also represents one of the most extreme conditions, particularly of temperature, that containers will ordinarily experience. Any of the three test methods described may be used to establish specifications for conformity to standard values, either as specified by a customer, an agency, or “The United States Pharmacopeia:”

    3.1.1 Test Method B-A  is intended particularly for testing glass containers primarily destined for containment of products with a pH under 5.

    3.1.2 Test Method B-W  is intended particularly for testing glass containers to be used for products with a pH of 5.0 or over.

    3.1.3 Test Method P-W  is a hydrolytic autoclave test primarily intended for evaluating samples from untreated glass containers. It is often useful for testing the resistance of containers of too small capacity to permit measurements of solubility on the unbroken article by the B-W test method. Yielding the water resistance of the bulk glass, it can also be used in conjunction with the B-W test method to distinguish whether the internal surface of a container has been treated to improve its durability.

    3.2 All three test methods are suitable for specification acceptance.

    1. Scope

    1.1 These test methods cover the evaluation of the resistance of glass containers to chemical attack. Three test methods are presented, as follows:

    1.1.1 Test Method B-A  covers autoclave tests at 121°C on bottles partially filled with dilute acid as the attacking medium.

    1.1.2 Test Method B-W  covers autoclave tests at 121°C on bottles partially filled with distilled water as the attacking medium.

    1.1.3 Test Method P-W  covers autoclave tests at 121°C on powdered samples with pure water as the attacking medium.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A569/A569M Specification for Steel, Carbon (0.15 Maximum, Percent), Hot-Rolled Sheet and Strip Commercial Withdrawn. The last approved version of this historical standard is referenced on

    D1125 Test Methods for Electrical Conductivity and Resistivity of Water

    D1193 Specification for Reagent Water

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    ICS Code

    ICS Number Code 81.040.30 (Glass products)

    UNSPSC Code

    UNSPSC Code 30171700(Glass products)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C0225-85R14

    Citation Format

    ASTM C225-85(2014), Standard Test Methods for Resistance of Glass Containers to Chemical Attack, ASTM International, West Conshohocken, PA, 2014,

    Back to Top