ASTM C1866 / C1866M - 20

    Standard Specification for Ground-Glass Pozzolan for Use in Concrete

    Active Standard ASTM C1866 / C1866M | Developed by Subcommittee: C09.24

    Book of Standards Volume: 04.02


      Format Pages Price  
    PDF 5 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $52.00   ADD TO CART



    1. Scope

    1.1 This specification covers ground-glass pozzolans for use in concrete where pozzolanic action is desired. This specification applies to ground glass from sources that consist of container glass, plate glass, or E-glass.

    1.2 The standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. If required results obtained from another standard are not reported in the same system of units as used by this standard, it is permitted to convert those results using the conversion factors found in the SI Quick Reference Guide.2

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

    C125 Terminology Relating to Concrete and Concrete Aggregates

    C150/C150M Specification for Portland Cement

    C204 Test Methods for Fineness of Hydraulic Cement by Air-Permeability Apparatus

    C311/C311M Test Methods for Sampling and Testing Fly Ash or Natural Pozzolans for Use in Portland-Cement Concrete

    C618 Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete

    C1069 Test Method for Specific Surface Area of Alumina or Quartz by Nitrogen Adsorption

    C1293 Test Method for Determination of Length Change of Concrete Due to Alkali-Silica Reaction

    C1567 Test Method for Determining the Potential Alkali-Silica Reactivity of Combinations of Cementitious Materials and Aggregate (Accelerated Mortar-Bar Method)

    C1778 Guide for Reducing the Risk of Deleterious Alkali-Aggregate Reaction in Concrete

    CSA Standards

    A3003 Chemical Test Methods for Cementitious Materials for Use in Concrete and Masonry (Contained in CSA A3000 Cementitious Materials Compendium)

    A3004-A4 Glass Content by the modified McMaster method (Contained in CSA A3000 Cementitious Materials Compendium)

    ACI Standards

    318-2019 Building Code Requirements for Structural Concrete and Commentary


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1866_C1866M-20

    Citation Format

    ASTM C1866 / C1866M-20, Standard Specification for Ground-Glass Pozzolan for Use in Concrete, ASTM International, West Conshohocken, PA, 2020, www.astm.org

    Back to Top