If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM C1692 - 18

    Standard Practice for Construction and Testing of Autoclaved Aerated Concrete (AAC) Masonry

    Active Standard ASTM C1692 | Developed by Subcommittee: C15.10

    Book of Standards Volume: 04.05

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $48.00   ADD TO CART
    Standard + Redline PDF Bundle 8 $56.00   ADD TO CART

    Significance and Use

    4.1 This practice applies to the materials and methods used in the construction of AAC masonry. It directly references the AAC materials standards under the jurisdiction of ASTM Committee C27 and the workmanship requirements of TMS 602 and supplements those workmanship requirements with additional requirements particular to AAC masonry.

    1. Scope

    1.1 This practice applies to construction and testing of masonry made of AAC units. It includes or references terminology, material specifications, and methods of test. It references specifications and test methods.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Other Standards

    TMS 402 Building Code Requirements for Masonry Structures Available from The Masonry Society, 105 South Sunset Street, Suite Q, Longmont, CO 805016172, http://www.masonrysociety.org.

    ASTM Standards

    C270 Specification for Mortar for Unit Masonry

    C476 Specification for Grout for Masonry

    C1072 Test Methods for Measurement of Masonry Flexural Bond Strength

    C1232 Terminology for Masonry

    C1660 Specification for Thin-bed Mortar for Autoclaved Aerated Concrete (AAC) Masonry

    C1691 Specification for Unreinforced Autoclaved Aerated Concrete (AAC) Masonry Units

    C1693 Specification for Autoclaved Aerated Concrete (AAC)

    C1717 Test Methods for Conducting Strength Tests of Masonry Wall Panels

    E96/E96M Test Methods for Water Vapor Transmission of Materials

    E514/E514M Test Method for Water Penetration and Leakage Through Masonry

    E518/E518M Test Methods for Flexural Bond Strength of Masonry

    E519/E519M Test Method for Diagonal Tension (Shear) in Masonry Assemblages

    ICS Code

    ICS Number Code 91.100.30 (Concrete and concrete products)

    UNSPSC Code

    UNSPSC Code 30111500(Concrete and mortars)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1692-18

    Citation Format

    ASTM C1692-18, Standard Practice for Construction and Testing of Autoclaved Aerated Concrete (AAC) Masonry, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top