ASTM C1666 / C1666M - 08(2015)

    Standard Specification for Alkali Resistant (AR) Glass Fiber for GFRC and Fiber-Reinforced Concrete and Cement

    Active Standard ASTM C1666 / C1666M | Developed by Subcommittee: C27.40

    Book of Standards Volume: 04.05

      Format Pages Price  
    PDF 4 $44.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $44.00   ADD TO CART

    1. Scope

    1.1 This specification covers minimum requirements for alkali resistant (AR) glass fibers intended for use in glass fiber-reinforced concrete (GFRC) by spray-up, glass fiber-reinforced concrete premix, fiber-reinforced concrete, and other cementitious based products.

    1.2 This specification provides for AR glass fiber types and configurations that can be readily incorporated into concrete mixes, typical physical properties, minimum zirconia content, and prescribes testing procedures to establish conformance to these requirements.

    1.3 This specification does not address the types of coatings or lubricants used in the manufacturing process of the fibers.

    1.4 In the case of conflict between a more stringent requirement of a product specification and a requirement of this specification, the product specification shall prevail. In the case of a conflict between a requirement of the product specification or a requirement of this specification and a more stringent requirement of the purchase order, the purchase order shall prevail. The purchase order requirements shall not take precedence if they, in any way, violate the requirements of the product specification or this specification; for example, by the waiving of a test requirement or by making a test requirement less stringent.

    1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D578 Specification for Glass Fiber Strands

    D1577 Test Methods for Linear Density of Textile Fibers

    D2256 Test Method for Tensile Properties of Yarns by the Single-Strand Method

    D3800 Test Method for Density of High-Modulus Fibers

    D4963 Test Method for Ignition Loss of Glass Strands and Fabrics

    ISO Standards

    ISO 1887 Textile Glass--Determination of Combustible- Matter Content

    ISO 1888 Textile Glass--Staple Fibres or Filaments--Determination of Average Diameter

    ISO 1889 Reinforcement Yarns--Determination of Linear Density

    ISO 3341 Textile Glass Yarns--Determination of Breaking Force and Breaking Elongation

    EN Standards

    Japanese Industrial Standards

    ICS Code

    ICS Number Code 91.100.40 (Products in fibre-reinforced cement)

    UNSPSC Code

    UNSPSC Code 30111901(Concrete reinforcing fiber)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1666_C1666M-08R15

    Citation Format

    ASTM C1666 / C1666M-08(2015), Standard Specification for Alkali Resistant (AR) Glass Fiber for GFRC and Fiber-Reinforced Concrete and Cement, ASTM International, West Conshohocken, PA, 2015,

    Back to Top