If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM C1651 - 11(2018)

    Standard Test Method for Measurement of Roll Wave Optical Distortion in Heat-Treated Flat Glass

    Active Standard ASTM C1651 | Developed by Subcommittee: C14.11

    Book of Standards Volume: 15.02

      Format Pages Price  
    PDF 6 $54.00   ADD TO CART
    Hardcopy (shipping and handling) 6 $54.00   ADD TO CART

    Significance and Use

    5.1 This test method is a procedure for determining the peak-to-valley depth and the wavelength of roll wave in flat glass and then calculating the optical distortion resulting from that roll wave. Peak-to-valley measurements provide a means of monitoring the roll wave distortion in a heat processed glass product.

    5.2 Measured peak-to-valley depth provides information required by some specifiers of heat-treated glass products.

    5.3 Roll wave is inherent in flat glass which has been heat treated in a furnace in which rollers are used to convey the glass.

    5.4 Consult Specifications C1036 and C1048 for additional glass characteristics and quality information.

    1. Scope

    1.1 This test method is applicable to the determination of the peak-to-valley depth and peak-to-peak distances of the out-of-plane deformation referred to as roll wave which occurs in flat, heat-treated architectural glass substrates processed in a heat processing continuous or oscillating conveyance oven.

    1.2 This test method does not address other flatness issues like edge kink, ream, pocket distortion, bow, or other distortions outside of roll wave as defined in this test method.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C162 Terminology of Glass and Glass Products

    C1036 Specification for Flat Glass

    C1048 Specification for Heat-Strengthened and Fully Tempered Flat Glass

    ICS Code

    ICS Number Code 81.040.20 (Glass in building)

    UNSPSC Code

    UNSPSC Code 30171700(Glass products)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1651-11R18

    Citation Format

    ASTM C1651-11(2018), Standard Test Method for Measurement of Roll Wave Optical Distortion in Heat-Treated Flat Glass, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top