| ||Format||Pages||Price|| |
|5||$50.00||  ADD TO CART|
|Hardcopy (shipping and handling)||5||$50.00||  ADD TO CART|
|Standard + Redline PDF Bundle||10||$60.00||  ADD TO CART|
This specification covers steel self-drilling and self-piercing tapping screws for the connection of cold-formed steel members manufactured. This specification also covers test methods for determining performance requirements such as dimension, and total case depth; and physical properties such as hardness, ductility, torsional strength, drill drive performance, and self-drilling tapping screw drill capacity.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers steel self-drilling and self-piercing tapping screws for the connection of cold-formed steel members manufactured in accordance with Specifications and . This specification also covers test methods for determining performance requirements and physical properties.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ANSI/ASME DocumentsANSI/ASME B18.18 Quality Assurance for Fasteners3 ANSI/ASME B18.6.4 Standard Specification for Thread Forming and Thread-Cutting Screws Available from American Society of Mechanical Engineers (ASME), ASME International Headquarters, Three Park Ave., New York, NY 10016-5990, http://www.asme.org.
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A510 Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel
A1040 Guide for Specifying Harmonized Standard Grade Compositions for Wrought Carbon, Low-Alloy, and Alloy Steels
B117 Practice for Operating Salt Spray (Fog) Apparatus
C11 Terminology Relating to Gypsum and Related Building Materials and Systems
C645 Specification for Nonstructural Steel Framing Members
C955 Specification for Cold-Formed Steel Structural Framing Members
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
F1941 Specification for Electrodeposited Coatings on Threaded Fasteners (Metric) F1941_F1941M
SAE StandardsSAE J78 SAE J933 Mechanical and Quality Requirements for Tapping Screws
ICS Number Code 21.060.10 (Bolts, screws, studs)
UNSPSC Code 31161507(Tapping screws)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C1513-18, Standard Specification for Steel Tapping Screws for Cold-Formed Steel Framing Connections, ASTM International, West Conshohocken, PA, 2018, www.astm.orgBack to Top