You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM C1380-04(2011)

    Standard Test Method for Determination of Uranium Content and Isotopic Composition by Isotope Dilution Mass Spectrometry (Withdrawn 2018)

    Withdrawn Standard: ASTM C1380-04(2011) | Developed by Subcommittee: C26.05


      Format Pages Price  
    PDF 4 $49.20   ADD TO CART

    ASTM License Agreement

    Work Item(s) - proposed revisions of this standard


    Withdrawn Rationale:

    This test method covered a method for the determination of the uranium concentration in uranium oxides by isotope dilution mass spectrometry (IDMS). The isotopic composition of the oxide was measured simultaneously.

    Formerly under the jurisdiction of Committee C26 on Nuclear Fuel Cycle, this test method was withdrawn in June 2018. This standard is being withdrawn without replacement because the information in this test method is duplicated in more detail in other ASTM standards; specifically, the dissolution of uranium oxide is covered in Practice C1347 and TIMS IDMS measurements in Test Methods C1625 and C1672.

    1. Scope

    1.1 This test method covers a method for the determination of the uranium concentration in uranium oxides by isotope dilution mass spectrometry (IDMS). The isotopic composition of the oxide is measured simultaneously.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1380-04R11

    Citation Format

    ASTM C1380-04(2011), Standard Test Method for Determination of Uranium Content and Isotopic Composition by Isotope Dilution Mass Spectrometry (Withdrawn 2018), ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top